0
Arlon DPF 8000 Ultra Tack Industrial Grade Film for Hard-to-Stick Surfaces (50 Yards Roll)
Arlon DPF 8000™ Ultra Tack Industrial Grade Film for Hard-to-Stick Surfaces
DPF 8000™ Ultra Tack is a 3.5-mil (90 micron) satin white, high-tensile, PVC film with aggressive, permanent pressure-sensitive adhesive. Designed to adhere to “hard-to-stick” surfaces, DPF 8000 Ultra Tack offers a special adhesive system that is designed to adhere to difficult substrates and low surface energy plastics, especially ABS plastic. DPF 8000 White is also designed to meet typical permanent marking requirements and specifications for heavy industrial equipment markings, including OEM markings, off-road vehicles such as motorbikes, and other hard-to-stick applications. The film installs best on flat surfaces when processed and applied according to Arlon recommendations. DPF 8000 Ultra Tack is fire certified under ASTM E-84 and EN 13501-1:2007+A1:2009 of Euro Class C, S1, d0. This product is also rated up to 7 years* (unprinted) for outdoor durability. Printed durability is dependent on the ink system used.
Applications & Features:
- Digital printing with a wide variety of direct print systems.
- Designed for “hard-to-stick” surfaces & ABS plastics.
- Application in cold temperature environments.
- Slightly textured and/or low-energy surfaces.
Technical Specifications:
- Surface Finish: Gloss Meter 60° Reflection – 40 to 60 Gloss Units.
- Thickness: 3.5-mil (90 micron).
- Tensile Strength: 13.0 lb/in (2.3 kg/cm).
- Elongation: Greater than 150%.
- Shelf Life (in box): 1 year from factory shipment when stored at 70°F (21°C) and 50% relative humidity.
- Application Temperature Range: 30°F to 80°F (optimum) on clean, dry substrate.
- Service Temperature Range: -65°F to 225°F (-54°C to 107°C) on clean, dry substrate.
- Dimensional Stability: 50 - 150 mil (1.27 - 3.81 mm) at 158°F (70°C) for 48 hours.
- Peel Adhesion: 5.0 lb/in (0.89 kg/cm) after 15 minutes at 70°F (21°C).
- Liner Release: 50 g/2 in (9.8 g/cm) at 90° release, 300 in/min (760 cm/min).
Preparation & Installations:
- General: DPF 8000 Ultra Tack features a high bond adhesive that results in visible shrinkage. Avoid leaving the printer unattended to prevent adhesive build-up on edges. Ensure solvents are completely removed before laminating or installation to avoid shrinkage and edge curl.
- Concrete, Masonry, and Tile: The surface must be dust-free. Clean using high-pressure TSP/water wash, then seal the surface with paint or concrete sealer and allow it to dry. Surfaces must be fully dry (48 hours after cleaning, 1 week after painting).
- Plastic: Slightly roughen the surface with sandpaper or oxidize with flame to improve adhesion on polyolefinic surfaces.
- Width: 30 Inches 60 Inches 54 Inches 49 Inches
- Length: 50 Yards
- Finish: Satin
- Brand: Arlon